by Sheila Hoffman | Jan 27, 2021 | Owners Manual
Tailwind e-Bike Manuals OLI Motor Manual – This PDF is the OLI motor manual (includes the battery access and computer info). While the manual doesn’t indicate you can switch from KM to Miles there is a way to do that. And this image is what the computer...
by Todd Shusterman | Sep 18, 2020 | Owners Manual
Eccentric / Timing Chain Adjustment As the cross over chains stretch, you will need to adjust the eccentrics to tension the chain. We switched from set screw type eccentrics to internal expanding eccentrics in 2004. Specific instructions for the set screw type will be...
by Todd Shusterman | Mar 15, 2013 | Owners Manual
Intermediate Shaft Disassemble the Intermediate Shaft & Remove the Timing Chains Without Loosening the Eccentrics If you do not have da Vinci Tool TL.001, insert two 5mm allen wrenches all the way into any two opposite holes of the DFB (Double Freewheel Block)....
by Todd Shusterman | Mar 15, 2013 | Owners Manual
Intermediate Shaft Bearings Removing the Bearings Pry the bearing spacer off center with a flat punch. Lightly tap the inner race of the bearing from the inside. You want the bearing to come out as straight as possible, so alternate tapping on the top and bottom of...
by Todd Shusterman | Mar 9, 2017 | Owners Manual
Anti-Chain-Suck (ACS) Bracket Adjustment If you have experienced chain-suck, (the chain gets stuck in the drive gears by wrapping around the chainring too far), your ACS bracket is adjusted too far from the chainrings, or the ACS bracket is bent, or both. The bracket...
by Todd Shusterman | Mar 15, 2013 | Owners Manual
Spindle Adjustment & Eccentric Maintenance This Information is for the pre 2005 Set Screw Type Eccentrics Removing the Eccentrics When servicing the eccentrics, it is best to remove them from the bike first. To do this all you have to do is loosen the set screws...
